Engine Bedini/Teslac 300w - 12-24v

Battery charger, (can replace a solar panel or another) extends their lifespan and gives them a second life with the possibility of using adjustable rotation up to 1200 revolutions per minute.
 
Comes with circuit and rotors assembled. Complete assembly optional. The double stacked DualPole 4 has now been significantly improved. Now comes with two Mosfets (1200V/100A) to allow higher voltage spikes while doing negative energy engineering on the output (third step process ideas), 1,2KV 76A SiC Schottky diodes and additional capacitors.
 
Also, starting from August 2021, the new stator coils have a better core material that is fully enclosed in our new coils. The tree is 3/8 ". The drive circuit is also improved with a new mosfet gate driver controlled by Arduino for enhanced speed control. The generator coils are also the same as the motor stator coils and allow a large output.
With this motor, you can use what has been called the third step process without having to use the trigger coil.
This engine can be stacked with a third layer or be only one layer. The motor can output a peak power up to 300W @12V (and this doubles with the doubling of the voltage). The 36-48 volt input requires a different code and a larger heat sink. Variac autotransformer optional for the loading of generator coils.
This is shown in our video. When the 4 (or 8 if you have a double stack motor) generator coils are in series, you can connect the two wires to the variac. Use at your own risk. We can only recommend that this be done by qualified technicians and in accordance with the requirements of the local code. When so connected, the motor accelerates with an appropriate load when the dial is turned down to 0-10V. 

As you increase it, the engine will slow down more and more. If the switch is off, the motor will slow down (if the dial was below 10V under load). This allows another gain in the motor and also as a variable output. Do not turn the knob when it is on (especially under high load) or it may arr
 
You can also add more coils around the motor coils as shown in our video to increase efficiency without affecting the motor function and its regular gains. This is also shown in our video above. Click the link to add as many reels as you want to your order. They do not represent a huge gain for the system, but they are important.

Since 9 April 2018, controller boards are delivered with an optional rotating battery integrated into the code. To activate the battery exchange code, place a jumper on pins 4 and 5 and use pins 3 and 6 to drive two mosfets to momentarily power alternative solinoids on a four-pole latch switch. See the video and diagram above for more details. Currently, we offer the lock switch.
 
Also optional upgrades, as shown in the following video: HV negative to positive energy switching inversion for battery Options to upgrade previous models: Mosfet 1200V 100A High speed diode 1200V SCR HF capacitor 450V low ESR